Three-Channel 16/20, 50A Total Temperature Control Module

  • Up to three individual temperature controlled switched receptacles available in one module
  • Each temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  • The channels are used to individually control and monitor the temperature of up to three single phase heating devices or provide over-temperature protection
  • Temperature feedback provided by RTDs or thermocouples
  • Ethernet Interface for simple configuration and expansion!
  • System-wide control of all Fideris Test System Components using FCPower Software
  • Integrated hardwired run/standby signal
  • Power Over Ethernet (PoE) for redundant power
  • Available with a fourth front panel temperature limit controller to cut-out heating or cooling process
  • Pigtail power input cord, IEC receptacles for individual channel outputs.

 

Specifications

Specifications of the Temperature Control Module

50 amps

16/20 Amps depending upon location
Electrical Requirements
26-50VDC
50 Amps
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum of four- 4 digit LED display
Maximum of four- RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
Pigtail (available with country specific plug)
Maximum of three IEC 309 or NEMA outputs (see manual for all available receptacles) operating at the same line voltage as the units line voltage input
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
35 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All

Summary

Can be ordered with one, two, or three independent temperature controlled channels.  Attached power cord inlet with country specific plug and IEC 309 or NEMA receptacles for each channel, each rated for 20A output in North America, 16A elsewhere.  Back panel connections for RTD or thermocouple inputs.