Three Channel 10/15 Amp Temperature Control Module (30Amp total)

  • Up to three individual temperature controlled switched receptacles available in one module
  • Each temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  • The channels are used to individually control and monitor the temperature of up to three heating devices
  • Provide over-temperature protection with an optional temperature limit cutout for a maximum of four front panel controllers
  •  Temperature feedback provided by RTDs or thermocouples
  •  Ethernet Interface for simple configuration and expansion!
  •  System-wide control of all Fideris Test System Components using FCPower Software
  •  Integrated hardwired run/standby signal
  •  Power Over Ethernet (PoE) for redundant power
  •  Also available in 3-phase and high current models

 

Specifications

Specifications of the Temperature Control Module

10 Amps VDE, CSA, 13 Amps UL standard, higher currents available

15 Amps
Electrical Requirements
26-50VDC
13 Amps @ 115 Volts, UL 10 Amps @ 230 Volts, VDE, CSA
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum of four- 4 digit LED display
Maximum of three- RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC-320 (mating cord provided)
Maximum of three- IEC-309 or NEMA outputs (see manual for specific receptacles available) operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
Dependent on configuration, approximately 17.5 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All

Summary

Up to three independent temperature control channels with optional temperature limit cutout for a maximum of four front panel controllers.  Front panel temperature controllers, internal main contactor and per channel solid state relays for control of two single-phase AC circuits with current ratings of 15 amps each in North America, 10 amps elsewhere. Total module current limited to 30 Amps. Back panel connections for RTD or thermocouple inputs. Back panel attached power cord with country specific plug.  Front panel circuit breaker.