Extended Range Liquid Delivery

MFC Liquid Front
MFC Liquid Front
MFC Liquid Back
MFC Liquid Back

 

  • Contains both a high flow and a low flow liquid mass flow controller which allows turndown ratios of up to 1000 to 1 in a single module
  • All-digital control eliminates analog calibration requirements and inaccuracies
  • Ethernet Interface for simple configuration and expansion!
  • The output from multiple Liquid Delivery Modules may be combined to provide dynamically controlled gas flow rates and compositions, including Stoichiometric control
  • System-wide control of all Fideris Test System components using
  • Integrated hardwired Run/Standby signal
  • Power Over Ethernet (PoE) for redundant power
  • Front panel LED status of Ethernet communications, inlet liquid pressure, liquid enabled, and power
  • Pressure regulator on inlet liquid lines to provide the highest degree of accuracy, and check valves for liquid backflow prevention

Specifications

Specifications of the MFC Liquid Delivery Module with Extended Range
Dual mass flow control (high flow/low flow) of one liquid
Solenoid valve or pneumatically operated bubble tight valve
125 PSI (8.62 Bar)
All digitally controlled brands available including Alicat, Bronkhorst, Brooks, or Sierra
Electrical Requirements
26-50VDC
Ethernet (DHCP)
Front Panel Controls and Displays
LCD with backlight, flow setpoint, and actual flow
Tx, Rx, Ident LEDs
LED illuminates above threshold pressure
Enabled LED
1 1/2" (optional)
Back Panel Connections
Molex 39660-1004
RJ45 (8P8C) Ethernet
Swagelok bulkhead union or optional quick-connect. 1/4" on 1U modules, 1/4" or 3/8" on 2U modules, 1/2" or 3/4" on 3U modules. VCR on optional UHP (Ultra-High Purity) models
Swagelok bulkhead union or optional quick-connect. 1/4" on 1U modules, 1/4" or 3/8" on 2U modules, 1/2" or 3/4" on 3U modules. VCR on optional UHP models
Physical Characteristics
1U Modules: 1.75", 2U Modules: 3.5", 3U Modules: 5.25" 19" rackmount; 21" deep
Dependent on configuration,approximately 15 lbs for 1U
40 to 100 degrees Fahrenheit, 85% RH
Indoors
Back: 6", Sides: 0", Top: 0"

316L (VAR if a welded component). Surface finish 10 micro-inch Ra

Each module provides a turnkey solution for mass flow control based liquid delivery to the fuel cell or other device under test. The module includes a bubble-tight inlet valve, upstream pressure regulator, and inlet pressure switch to notify the system when liquid is present. The mass flow controller is followed with a reverse flow protection check-valve to prevent contaminants from migrating upstream to the MFC. Front panel display of status provides for quick verification and easy diagnostics. The module comes in a standard rack mount size for simple integration into an existing test stand or as part of a custom configured Fideris Test Stand. Most common uses include gas delivery fo