Dual Channel 15/20 amp (30A total) Temperature Control Module

  • One or two individual temperature controlled switched heater receptacles available in one module
  • Each temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  •  The channels are used to individually control and monitor the temperature of up external heaters or heating / cooling systems
  • Available with individual or system-wide temperature limit protection
  •  Temperature feedback provided by RTDs or thermocouples
  •  Ethernet Interface for simple configuration and expansion!
  •  System-wide control of all Fideris Test System Components using FCPower Software
  •  Integrated hardwired run/standby signal
  •  Power Over Ethernet (PoE) for redundant power
  •  Also available in 3-phase and higher current models as well as lower-current / higher-channel models



Specifications of the Temperature Control Module

10 amps VDE, CSA, 13 amps UL standard, higher currents available

6 amps standard
Electrical Requirements
13 Amps @ 115 Volts, UL 10 Amps @ 230 Volts, VDE, CSA
50/60 Hz

Front Panel Controls and Displays

Maximum of six- 4 digit LED display
Maximum of six- RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC-320 (mating cord provided)
Maximum of two IEC 309 or NEMA twist lock outputs (see manual for specific receptacle types) operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
10 lbs
40 to 100 Fahrenheit, 85% RH
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All


One or two front panel temperature controllers with solid state relays for control single-pole or two-pole heater or heating/cooling circuits with current ratings of 15 amps or 20 amps each. Total module current limited to 30 Amps. Back panel connections for RTD or thermocouple inputs. NEMA twist lock power inlet and outlets.