75 Amp Three-Phase Temperature Control Module

  • 75 Amp three phase temperature controlled switched receptacle
  • Temperature control based on Cal Controls or Watlow controllers with auto-tune capabilities
  • Control and monitor the temperature of a 75 Amp three phase heating device or provide over-temperature protection
  • Temperature feedback provided by RTDs or thermocouples
  • Ethernet Interface for simple configuration and expansion!
  • System-wide control of all Fideris Test System Components using FCPower Software
  • Integrated hardwired run/standby signal
  • Power Over Ethernet (PoE) for redundant power
  • Also available in single phase and low current models

 

Specifications

Specifications of the Temperature Control Module

75 Amps
Electrical Requirements
26-50VDC
75 Amps
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum two 4 digit LED display
Maximum of three RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC 309 (mating cord provided)
IEC 309 or NEMA output receptacles operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
Dependent on configuration,approximately 18 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All

Summary

Single 75 Amp temperature control module with solid state relays for control of one three-phase circuit with current rating of 75 Amps. Back panel connections for RTD or thermocouple inputs. Direct wired or IEC 309 back panel power inlet with circuit breaker and IEC power outlets.