6 Amp x 6 Channel Temperature Control Module (30Amps total per module)

  • Up to six individual temperature controlled switched receptacles available in one module
  • Each temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  •  The channels are used to individually control and monitor the temperature of up to six heating devices or provide over-temperature protection
  •  Temperature feedback provided by RTDs or thermocouples
  •  Ethernet Interface for simple configuration and expansion!
  •  System-wide control of all Fideris Test System Components using FCPower Software
  •  Integrated hardwired run/standby signal
  •  Power Over Ethernet (PoE) for redundant power
  •  Also available in 3-phase and high current models

 

Specifications

Specifications of the Temperature Control Module

30 amps VDE, CSA, 13 amps UL standard, higher currents available

6 amps standard
Electrical Requirements
26-50VDC
13 Amps @ 115 Volts, UL 10 Amps @ 230 Volts, VDE, CSA
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum of six- 4 digit LED display
Maximum of six- RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232

NEMA L5-30

IEC60309 6H
Maximum of six- IEC-320 outputs operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
10 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All

Summary

If your process needs individual control of up to six heating channels with a total current load under 30 Amps, then the Fideris 6x6 temperature controller may be the perfect match.  Each channel has an independent front panel temperature controller with full PID control, display, and auto tune capabilities.  A master relay provides an overall hardwired shutdown of the unit and individual back panel circuit breakers protect individual channels.  To provide redundancy in critical heating or cooling operations, the unit can be ordered with any channel operating as a temperature alarm for any of the control channels.  Front panel display of status provides for quick verification and easy diagnostics. The module comes in a standard rack mount size for simple integration into an existing fuel cell test stand or as part of a custom configured Fideris Fuel Cell Test Stand. Back panel connections for RTD or thermocouple inputs. The North American version that has a NEMA L5-30 attached power cord and the international version has a IEC60309 6H attached power cord.