6 Amp x 6 Channel Temperature Control Module (10 Amps total per module)

  • Up to six individual temperature controlled switched receptacles available in one module
  • Each temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  •  The channels are used to individually control and monitor the temperature of up to six heating devices or provide over-temperature protection
  •  Temperature feedback provided by RTDs or thermocouples
  •  Ethernet Interface for simple configuration and expansion!
  •  System-wide control of all Fideris Test System Components using FCPower Software
  •  Integrated hardwired run/standby signal
  •  Power Over Ethernet (PoE) for redundant power
  •  Also available in 3-phase and high current models

 

Specifications

Specifications of the Temperature Control Module

10 amps VDE, CSA, 13 amps UL standard, higher currents available

6 amps standard
Electrical Requirements
26-50VDC
13 Amps @ 115 Volts, UL 10 Amps @ 230 Volts, VDE, CSA
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum of six- 4 digit LED display
Maximum of six- RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC 60320-C14 (Country specific mating cord included)
Maximum of six- IEC-320 outputs operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
10 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document