50 Amp 3-Phase Temperature Controller

  • 50 Amp three phase temperature controlled switched receptacle
  • Temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  • Control and monitor the temperature of a 50 Amp three phase heating device or provide over-temperature protection
  • Temperature feedback provided by RTDs or thermocouples
  • Ethernet Interface for simple configuration and expansion!
  • System-wide control of all Fideris Test System Components using FCPower Software
  • Integrated hardwired run/standby signal
  • Power Over Ethernet (PoE) for redundant power
  • Also available in single phase and high current models



Specifications of the Temperature Control Module

50 Amps
Electrical Requirements
50 Amps
50/60 Hz

Front Panel Controls and Displays

Maximum of two 4 digit LED display
Maximum of three RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC 309 (mating cord provided)
IEC 309 or NEMA outputs operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
Dependent on configuration,approximately 18 lbs
40 to 100 Fahrenheit, 85% RH
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All



Attached power cord inlet, available with NEMA or IEC outlet