30 Amp 3-phase Temperature Control Module

  • Single channel, three-phase temperature control module with current output up to 30 Amps
  • Back panel NEMA twist lock or IEC 309 connections for power input and heater power output
  • Temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  • Can be ordered with external analog or pneumatic output for proportional cooling valve
  • Available with internal power supply to provide operation power to external analog valve (e.g., 24VDC, 24VAC, 48VDC, 48VAC, etc.)
  • Temperature limit cutouts available to stop process from heating and/or cooling when temperature limit is reached
  • Temperature feedback provided by RTDs or thermocouples
  • Ethernet Interface for simple configuration and expansion!
  • System-wide control of all Fideris Test System Components using FCPower Software
  • Integrated hardwired run/standby signal
  • Power Over Ethernet (PoE) for redundant power

Specifications

Specifications of the Temperature Control Module

30 Amps
Electrical Requirements
26-50VDC
30 Amps
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum of two 4 digit LED display
Maximum of three RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC 309 or NEMA twist lock (mating cord provided)
IEC 309 or NEMA twist lock outputs operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
Dependent on configuration,approximately 18 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All

Summary

Up to two front panel temperature controllers with solid state relays for control of each phase with current ratings of 30 Amps each. NEMA or IEC 309 back panel power inlet with circuit breaker and IEC power outlets.