20 Amp Three-Phase Temperature Controller

  • Three phase 20 Amp temperature controlled switched receptacle
  • Temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  • The channels are used to individually control and monitor the temperature of a 20 Amp three phase heating device or provide over-temperature protection
  • Temperature feedback provided by RTDs or thermocouples
  • Ethernet Interface for simple configuration and expansion!
  • System-wide control of all Fideris Test System Components usingFCPower Software
  •  Integrated hardwired run/standby signal
  •  Power Over Ethernet (PoE) for redundant power
  •  Also available in single phase and high current models

 

Specifications

Specifications of the Temperature Control Module

20 Amps
Electrical Requirements
26-50VDC
20 Amps
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum of two 4 digit LED display
Maximum of three RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC 309 or NEMA twist lock (mating cord provided)
IEC 309 or NEMA twist lock output receptacles operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
Dependent on configuration,approximately 18 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All

Summary

Two front panel temperature controllers, a primary controller and independent overtemperature cutout. Internal solid state relays for control of three phase AC circuits with current ratings of 20 amps each. Back panel connections for RTD or thermocouple inputs. Direct wired or IEC 309 power inlet connection with circuit breaker.