150 Watt Electronic Load with 10-Channel Cell Voltage Measurement Inputs

 

  • Fully programmable, self-contained, air cooled solid state load
  • Patented design is optimized to provide ultra-low impedance operation for fuel cell testing
  • Load is compatible with AC impedance or frequency response analyzers
  • Interchangeable shunts for precise operation over a wide dynamic range
  • Ten built-in voltage monitoring inputs optional. Additional voltage monitoring inputs available
  • Ethernet Interface for simple configuration and expansion!
  • Combine with additional Fideris Innovator Series modules to create a fully-integrated, fully-automated, customized test system
  • System-wide control of all Fideris Test System Components using FCPower Software, Labview, or other programming language
  • Integrated hardwired Run/Standby signal

Specifications

Specifications of the 150 Watt Electronic Load Module with 10-Channel Cell Voltage Measurement Inputs
MOSFET variable resistance loadbank
Exchangeable shunt (determines maximum current). 1A, 2A, 5A, 10A, 20A, or 50A shunts available
50A. Higher current version available
20V standard, 55V available
150W
< 3 milliohms standard; lower resistance available
All critical components gold-plated
16-bit precision of full scale measurement
16-bit precision of full scale measurement
Electrical Requirements
26-50VDC
Ethernet (DHCP)
Front Panel Controls and Displays
LCD with backlight, current, and voltage
Tx, Rx, Ident LEDs
Enabled LED
Back Panel Connections
Molex 39660-1004
RJ45 (8P8C) Ethernet
DB-25, available as an option
4 pin AMP CPC
5/16" bolt down terminals standard
Physical Characteristics
3.5" high (2U) 19" rackmount; 21" deep
Dependent on configuration, approximately 30 lbs
40 to 100 degrees Fahrenheit, 85% RH
Indoors
Back: 8", Sides: 0", Top: 0"
Download Document
View All

Note: Loads can be ordered with or without integrated 10-channel voltage measurement.