15 Amp Three-Phase Temperature Control Module

  • Front panel controller for a single 3-phase heater output
  • Each temperature controlled channel based on Cal Controls or Watlow controllers with auto-tune capabilities
  • Optional internal supply for power to external low voltage device such as valve
  •  Temperature feedback provided by RTDs or thermocouples
  •  Ethernet Interface for simple configuration and expansion!
  •  System-wide control of all Fideris Test System Components using FCPower Software
  •  Integrated hardwired run/standby signal
  •  Power Over Ethernet (PoE) for redundant power

 

Specifications

Specifications of the Temperature Control Module

15 amps
Electrical Requirements
26-50VDC
15 Amps
50/60 Hz

240VAC
Front Panel Controls and Displays

Maximum of two 4 digit LED displays
Maximum of three RTD or mini-thermocouple
Power, Output Enable, Ethernet Tx, Ethernet Rx, 10 ENT, Status LCD
Back Panel Connections
Ethernet or RS-232
IEC 309 or NEMA twist lock (mating cord provided)
IEC 309 or NEMA twist lock output receptacles operating at the same line voltage as the unit
Physical Characteristics
2U Modules: 3.5" 19" rackmount; 21" deep
10 lbs
40 to 100 Fahrenheit, 85% RH
Indoors
Front: 6", Back: 6", Sides: 0", Top: 0"
Download Document
View All

Summary

Unit has a single 15 amp, 3-phase output with dedicated front panel temperature controller.  In addition to main power output for heater control, unit is available with overtemperature cutout controller as well as heat/cool controller with analog output for control of an external proportional valve or other digital or analog cooing operation.  Also available with internal low voltage output for power of external positioner or pneumatic control output.